Proface LT4300M - 5.7 Modular HMI + Control" Manual de usuario descargar pdf (Pagina 35)

LT-4201TM/4301TM Installation Guide

English

Power Cord Preparation

Before using your power cord:

 Verify that the ground wire is the same gauge or heavier than the power wires.

 Do not use aluminum wires for the power supply’s power cord.

 If the conductor end (individual) wires are not twisted correctly, the end wires may either

short loop to each other or against an electrode. To avoid this, use D25CE/AZ5CE cable

ends.

 Use wires that are 0.75 to 2.5 mm

(18 to 12 AWG) for the power cord, and twist the wire

ends before attaching the terminals.

 The conductor type is solid or stranded wire.

 To reduce electromagnetic noise, make the power cord as short as possible.

Power Plug Illustration

Connecting the Power Cord

The table explains how to connect the power plug:

Connection Wire

+24Vdc

-0Vdc

FG Grounded terminal connected to the unit chassis

Step Action

1 Confirm the power cord is not connected to the power supply.

2 Check the rated voltage and remove the "DC24V" sticker on the DC power supply

connector.

3 Remove 10 mm (0.39 in.) of the vinyl membrane off the ends of the power code wires.

4 If using stranded wire, twist the ends. Tinning the ends with solder reduces risk of

fraying and ensures good electrical transfer.

5 Push the Opening button with a small and flat screwdriver to open the desired pin hole.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 46 47

Sin comentarios

Proface LT4300M - 5.7 Modular HMI + Control" Manual de usuario Pagina 35