Proface FP3900 - 19 Flat Panel" Manual de usuario

1 FP unit (1)  Installation Guide (1) (this manual)  Warning/Caution Information (1) Installation Gasket (1) (attached to the FP unit) Installati

10Pin Assignments and Signal Names for DVI-DConnector ... DVI-D 24-pin maleConnector set screw ... Inch type (#4-40UNC)Cable DVI-

11 Serial InterfacePin Assignments and Signal Names for Serial Interface *1 The CD, DTR, and DSR are connected together insid

12(1) According to the Panel Cut size, make installation holes on the panel. Also, determine the panel thickness according to the panel thickness rang

13• To avoid an electric shock, when connecting the FP’s power cord terminals to the power terminal block, confirm that the FP’s power supply is compl

14 FP3500-T11/FP3600-T11/FP3650-T41 (Type AC)Power Cable ConnectingConnecting the FP Power Cord(1) Be sure that the FP’s power cord is not plugged

15 FP3500-T41-24V/FP3600-T41-24V (Type DC)Power Cable specificationUse copper conductors only.Power connector specificationUse the following wiring

16Power cable connecting(1) Make sure that the power cable has no power distribution.(2) Remove the power connector from the unit.(3) There are three

17Please pay special attention to the following instructions when connecting the power cord terminals to the FP unit.• If the power supply voltage exc

18 Starting the OSDTo start the OSD and enter OSD mode, press the three corners of the touch panel in turn (upper left, upper right, and lower right)

19 Top Main• In the OSD, pressing the button applies the set value and enables the setting. The set value won’t be canceled unless the po

2 Qualified Product (UL File No.E220851, CSA File No.219866)The following units are UL/c-UL/CSA listed products.(UL File No.E220851, CSA File No.2198

20 720x400 ModeWhen an input data resolution of 720 x 400 is used in the VGA text mode, set this parameter to ON. For other resolutions, set this pa

21Applies the setting and then returns to the top menu.Cancels the setting and then returns to the top menu.• Be sure to perform the auto gain control

22

3The FP3650-T41 is a CE marked product complying with both the EMC Directive and low voltage directive.It complies with EN55011 Class A, EN61000-6-2 a

41 Part Names CDEFGHFront ViewRear ViewBottom ViewA,BJIThis model is FP3600-T11.A: TFT Color LCD Acts as a display monitor for your host.B: Touch Pa

5 The Dip Switches and Slide Switch are located in the bottom of the FP unit. Only the settings when the power supply is turned on is effective to t

6 Analog RGB InterfaceDisplay Area (FP3500-T11/FP3500-T41-24V)4 InterfacesInput signal type Analog RGBInput signal characteristicImage signal

7(FP3600-T11/FP3600-T41-24V)(FP3650-T41)SizeH Sync. (kHz)V Sync. (Hz)Dot Clock (MHz)Screen Resolution Expansion(H: Horizontal) (V: Vertical)Display R

8Pin Assignments and Signal Names for Analog RGBConnector ... Mini Dsub 15 pin maleConnector set screw ... Inch type (#4-40UNC)Ca

9(FP3600-T11/FP3600-T41-24):(FP3650-T41)SizeH Sync. (kHz)V Sync. (Hz)Dot Clock (MHz)Screen Resolution Expansion(H: Horizontal) (V: Vertical)Displa