Proface APL3000B - Node Box PC Manual de usuario descargar pdf (Pagina 107)

PS-3710A/PS-3711A Series Hardware Manual

4-10

4.5.2 PS-3711A Series

Be sure to wear gloves when exchanging the backlight, and follow the following procedures.

(1) Confirm that the power is not supplied to the PS-A unit, and remove the power cable.

(2) Remove the PS-A unit from the equipment (panel etc.) to which the unit has been incorporated, and

place the PS-A unit on a flat, level surface facing the display face downwards.

(3) Remove the PS-A’s rear cover.

(4) Insert a screwdriver into the two holes (points) shown below, and remove the backlight attachment

screws (1 per hole).

• Be sure to perform the backlight changeover on a flat, level surface. This will

prevent damage to the PS-A unit and the accidental cutting of any of its power

cord.

• Be sure to protect the display surface to prevent damage during the operations.

SEE

3.2.1 Removal/Attachment the Rear Cover (page 3-6)

Insert a screw driver

(2 holes)

PCMCIA

unit

HDD unit

CF Card unit

1 2 ... 102 103 104 105 106 107 108 109 110 111

Sin comentarios

Proface APL3000B - Node Box PC Manual de usuario Pagina 107